The Height Adjuster Assembly - Toro Greensmaster e1021 Service Manual

The Height Adjuster Assembly

g282214
1. Cotter pin
2. Clevis pin
3. Height adjustment rod
4. Flange nut
5. Washer (2 each)
6. Compression spring
Disassembling the Height Adjuster
Greensmaster ® e1021/e1026
20246SL Rev A
7. Compression spring
8. Bumper
9. Lock nut
10. Pinch bolt
11. Height-of-cut bracket
12. Quick up lever
Note: Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended; refer to
Note: Refer to Figure 124
1. Remove the cutting unit from the machine.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the pinch bolts that secure the front roller to the height-of-cut
brackets.
Figure 124
13.
14.
15.
16.
17.
18.
during this procedure.
Page 8–17 Universal Groomer (Optional): Service and Repairs
Quick up cover
Detent spring
Button-head screw
Height adjuster knob
Height adjustment bolt
Plow bolt
Figure 125.