Toro Greensmaster e1021 Service Manual page 64

Disassembling the Drum Drive Assembly
g258879
1. Traction drum (2 each)
2. Bolt (8 each)
3. Lock washer (8 each)
4. Drum hub plate (2 each)
Traction and Reel Drive Systems: Service and Repairs
5. Drum spindle
6. Seal (2 each)
7. Ball bearing (2 each)
8. Spacer
Note: Refer to Figure 21
1. Remove the 4 bolts (2) and lock washers (3) that secures the drum hub plate
(4) to the drum spindle (5).
2. Remove the 4 bolts (2) and lock washers (3) that secures the drum hub
plate (4) to the drum hub (10).
3. Remove the shoulder bolts (11) that secures the drum hub plate (4) to the
traction drum (1).
4. Remove the lock nut (12) that secures the drum spindle (5) and drum hub
(10) together. Carefully slide and remove the drum spindle (5) out of the
drum hub (10).
5. Remove the 2 seals (6) from the drum hub (10). Use a press to remove the 2
ball bearings (7) and a bearing spacer (8) from the drum hub (10). Discard
the ball bearings.
Figure 21
10.
11.
12.
during this procedure.
Page 4–18
9. Spacer
Drum hub
Shoulder bolt (6 each)
Lock nut
Greensmaster
20246SL Rev A
® e1021/e1026