The Height Adjuster Assembly - Toro Greensmaster eFlex 1021 Service Manual

The Height Adjuster Assembly

g251107
1. Height adjuster knob
2. Carriage bolt
3. Height-of-cut bracket
4. Flange nut
5. Groomer hose
Disassembling the Height Adjuster
Universal Groomer (Optional): Service and Repairs
6. Washer (2 each)
7. Compression spring
8. Flange nut
9. Height adjustment rod
10. Groomer pin
Note: Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the 2 height adjustment bolts and 2 locknuts.
4. Remove the flange nut (item 4 in
the height adjuster assembly to the cutting unit side plate, and remove the
front roller and height adjuster from the cutting unit.
5. Disassemble the height adjuster assembly as necessary.
6. Clean all the components and inspect for wear or damage. Replace all the
components that are worn or damaged.
Figure 125
11.
12.
13.
14.
15.
Figure 125) and carriage bolt that secure
Page 8–18
Quick up lever
Quick up cover
Detent spring
Button-head screw
Height adjustment bolt
Greensmaster ® eFlex 1021
20248SL Rev A