Toro Greensmaster e1021 Service Manual page 196

Removing the Gear Box Assembly (continued)
Universal Groomer (Optional): Service and Repairs
9. Rest the handle of the pry bar against the front roller and turn the drive shaft
counterclockwise to loosen it from the reel. Continue to unscrew the drive
shaft and remove the gear box from the cutting unit.
g330869
1. Socket head screw (4 each)
2. Gear box cover assembly
3. Cover gasket
4. Driven gear
5. Thrust washer
6. Ring gear
7. Flange bushing
10. If the hex head on the end of the drive shaft is damaged during removal:
A. Remove the drain/fill plug and drain the oil from the gear box.
B. Remove the 4 socket-head screws and remove the gear box cover
assembly and driven gear. Remove and discard the cover gasket.
C. Slide the thrust washer, ring gear and bushing from the gear box housing.
D. Slide the sun gear, and planet gears and bushings from the pins on the
gear box housing.
E. Remove the retaining ring from the drive shaft.
F. Slide the groomer housing assembly from the drive shaft.
G. Tip up the cutting unit to access the bottom of the reel to remove the
drive shaft assembly.
Figure 117
8. Sun gear
9. Planet gear (3 each)
10. Flange bushing (3 each)
11. Retaining ring
12. Gear box housing assembly
13. Damaged drive shaft
Page 8–6 Greensmaster ® e1021/e1026
20246SL Rev A