TC Inputs
NOTE A "load" in a circuit schematic is a component or portion of the
circuit that consumes electric power. For the diagrams shown in
this document, "load" refers to the devices or systems connected
to the remote I/O unit.
Mounting
There are two sliders on the back of the unit for DIN rail and wall
mounting.
1. Mounting on a DIN rail: Pull out the bottom slider; latch the unit
onto the DIN-rail, and push the slider back in.
2. Mounting on the wall: Pull out both the top and bottom sliders and
align the screws accordingly.
Connecting the Power
Connect the +12 to +36 VDC power line to the ioLogik E1200's terminal
block V+ terminal; connect the ground from the power supply to the V-
terminal. Connect the ground pin (
NOTE For safety reasons, wires connecting the power supply should be
at least 2 mm in diameter (e.g., 12 gauge wires).
Connecting to the Network
The ioLogik E1200 has two built-in RJ45 Ethernet ports for connecting
standard direct or cross-over Ethernet cables.
) if earth ground is available.
- 4 -