DAYLIFF SUNVERTER 3 Installation & Operating Manual page 8

2.3 Wiring
Wiring must be performed by a qualied electric
professional, else may cause electric shock or re.
WARNING
Always ensure input power is isolated before wiring and
connection; else may cause electric shock or re.
WARNING
Earth terminal must be reliably grounded, or else inverter
enclosure may be electried.
WARNING
The selection of solar array, motor and inverters should be
reasonable, in case of doubt, consult nearest dealer.
NOTE
2.4 Connection
cause re
CAUTION
lter with inverter output.
CAUTION
Make sure all the wiring and connection are correctly
connected before powering on, or else may damage the PV
disconnect box or cause re.
CAUTION
2.5 Running
Do not change wiring and connection when the inverter is
powered, else may cause electric shock.
WARNING
Before operation, adjust the function parameters according
to the steps indicated in this manual. Do not change the
function parameters of the inverter randomly, else may cause
CAUTION
damage to the equipment.
The temperature of heat sink is normally high during running
and it should not be touched, else may cause burns.
CAUTION
Ensure to fasten terminal with specied torque, or else may
Do not connect capacitor or phase-advanced LC/RC noise
4