View Or Modify Control Parameter - DAYLIFF SUNVERTER 3 Installation & Operating Manual

4.6 View or Modify Control Parameter

Operation
Initial Status: non-control
parameter display
PROG
or or
ENTER
or or
ENTER
PROG
When the inverter is operating, the control parameter can
only be viewed. To modify, the inverter must rst be stopped.
NOTE
Description
E n t e r t h e p a r a m e t e r
modification interface: Display
menu type, parameter number,
parameter value, parameter
meaning of the inverter.
Select the parameter to be
viewed and modified: Parameter
number can be viewed or
modified when the cursor is at the
end of the parameter number.
Confirm the parameter to view or
modify: The cursor will move to
the end of parameter value line.
Modify the parameter value:
When the cursor is at the end of
parameter value line, the
p a r a m e t e r v a l u e c a n b e
modified.
C o n f i r m a n d s a v e t h e
modification: Cursor moves to
the end of parameter number
line.
Quit from the parameter display
mode. Display current running
data
22
Display