Advertisement
3. Commands Set Reference
S76G/S78G commands set can be categorized into 4 types: SIP command, MAC (LoRaWAN
command. SIP commands are controlling commands that are relevant or direct MCU control and
not related to radio transmission. MAC commands are used to utilize LoRaWAN
communicate with Servers or modify LoRaWAN
commands can control SONY CXD5603GF GPS chip by GPS commands or receive GPS responses.
The command set interface is readable ASCII string. S76G/S78G starts to accept command if
the string starts from these "sip", "mac" and "gps" prefixes, and the response string from
S76G/S78G starts with two '>' characters and one 'space'. For example, the first line of the
below demo is a module command, and the second line is the response from S76G/S78G.
sip get_ver
>> v1.0.8
3.1 SIP commands
3.1.1 sip factory_reset
Response: A string representing firmware version.
Purpose: All LoRaWAN
Example:
sip factory_reset
>> v1.0.8
3.1.2 sip get_ver
Response: A string representing firmware version.
Purpose: Get current firmware version.
Example:
sip get_ver
>> v1.0.8
3.1.3 sip reset
Response: The beginning information since FW starts.
Purpose: This command resets the module and start FW over again.
Example:
sip reset
>> S76G - v1.0.8 - Nov 10 2016 - 17:05:43
TM
and radio configuration parameters will be set to default value.
Product Name
TM
related parameters. GPS (gps mode)
S76G/S78G Commands Set Reference
Version
v1.6.5
Doc No
Date
July 2, 2018
Page
12 of 73
TM
)
TM
protocol to
Advertisement
