Setting The Key Tone; Set Warning Tone; Set Lcdbrightness Level; Setting The Display Readiness - sauter TO-EE Instruction Manual

Multimode ultrasonic material thickness gauge

Table of Contents

5.11 Setting the key tone

The key tone can be switched on or off. If the key tone is switched on, the buzzer in

the device emits a short acoustic alarm after each key is pressed.

The warning tone can be switched on or off. If the warning tone is switched on, the

buzzer in the device emits a long acoustic alarm after each new measured value. If the

instrument emits an action warning, an alarm will also sound if the setting is activated.

The different brightness levels of the LCD screen affect the standby time and

continuous operation.

The setting can be changed by scrolling with the F1 (increase) and F2 (decrease) keys

or by pressing the arrow keys.

Press the key

or the F3 key to confirm the setting.

Press the button

to cancel the change and exit the dialog box.

With lower brightness, less power is consumed and therefore the operating time is

extended.

Note: Reduce the brightness of the LCD screen in good lighting conditions to

save energy.

For the settings, refer to the right figure of the Display Standby Delay dialog box.

Press the arrow keys or the F2 key to select the desired setting.

Selecting the "Disable" option prevents the unit from switching to standby mode.

The device goes into standby mode after a certain time. Perform a measurement or

press any key to wake the unit from standby mode.

The standby mode reduces the LCD brightness and puts the CPU into a power saving

mode. Switching from power mode to standby mode is controlled by setting the

"Display Standby Delay" function.

TO-BA-e-2020

Table of Contents