sauter TO-EE Instruction Manual page 22

5.10.3 Select current data group
The meter contains 100 data groups (F00 ~ F99) in which the measured values can
be stored. A maximum of 100 data sets (thickness values) can be stored in each group.
To change the target data group for storing measured values, proceed as follows:
Activate the "Memory Manager" function. Press
group. Press F2 to retrieve the command list. Then select the "Set" command and
confirm it with .
After completing the above steps, the newly selected data group is set as the current
data group for storing new measurement results.
5.10.4 Delete data group
It may be necessary to completely delete all measurements of an entire data group. In
this way, the user can create a new list of measurements, starting from memory
location no. 00. The procedure is described in the following steps.
Activate the "Memory Manager" function.
Press or to
command list. Then select the "Clear" command and confirm it with
If the command "Clear All" is selected and confirmed, all data groups of the measuring
instrument are deleted.
Note: The data cannot be restored after deletion!
22
select the desired data group. Press the F2 key to display the
or to select the desired data
.
TO-BA-e-2020