Daewoo DE12T Manual page 86

3.3.12. Fuel injection pump drive gear
•
Mount gasket by aligning the bolt
holes with the pin holes on the bear-
ing housing.
•
Tighten the fixing bolts in the direc-
tion of fuel injection pump.
3.3.13. Timing gear case cover
•
Install dowel pin on the timing gear
case.
•
Mount a gasket by aligning the fixing
bolt holes with those on the gasket.
•
Align the dowel pin with the cover pin
hole, then install the cover with light tap.
•
Tighten the fixing bolts beginning
with the oil pan fitting face.
3.3.14. Front oil seal
•
Apply lubricating oil to the outside of
the oil seal and timing gear case
inside diameter and fit them over the
crankshaft, then assemble the oil seal
using an oil seal fitting jig.
3.3.15. Cylinder liner
•
Stand the cylinder block so that the
flywheel faces downward.
•
Thoroughly clean the liner flange fit-
ting surface and bore inside with com-
pressed air to prevent the entry of for-
eign substances.
•
After the cleaning operation, make the
cylinder liner dried up and push it into
the cylinder block by hand.
•
Wet the liner inside diameter with
engine oil.
REASSEMBLY
- 82 -
EAMD027I
오일시일 고정지그
Oil seal fitting jig
EAMD086I
EAMD087I