Daewoo DE12T Manual page 85

3.3.10. Timing gear case
•
Mount gasket using dowel pin on the
cylinder block.
•
Install the timing gear case by aligning
the dowel pin with the dowel pin hole
on the timing gear case.
3.3.11. Timing gear
•
Install the oil pump idle gear onto the
No.7 bearing cap.
•
Install a thrust
camshaft and assemble the cam gear
by aligning it with camshaft key groove.
Torque
End play
0.13 ~ 0.27 mm
•
With the oil port on the idle gear pin
facing the cylinder block, install the
idle gear pin.
•
Install the idle gear by coinciding the
marks impressed on the crank gear,
cam gear, fuel injection pump drive
gear, and idle gear.
•
Install a thrust washer on the idle gear
and tighten to specified torque.
Torque
•
Check and adjust the amount of back-
lash between gears using a feeler
gauge.
Backlash
washer over the
3.8 kg . m
Limit
0.30 mm
7.4 kg . m
0.15 ~ 0.25 mm
- 81 -
아이들 기어 핀 Idle gear pin
아이들 기어 핀
Idle gear pin
표시 "2" Mark "2"
Fuel injection
연료 분사 펌프
pump drive gear
드라이브 기어
2
2
2
Idle gear
아이들 기어
크랭크
표시 "0"
Mark "0"
기어
EAMD082I
EAMD083I
EA8M3004
캠 기어
Cam gear
1
1
1
Mark "1"
표시 "1"
EA8M3005
REASSEMBLY