3.2.7. Crank shaft bearing and connection rod bearing
1) Visual check
•
Visually check the crankshaft bearing and connecting rod bearing for scores, uneven wear
or damage.
2) Oil clearance between crankshaft and bearing.
•
Main bearing clearance
Install the main bearing in the cylinder
block, tighten the bearing cap to spec-
ified torque, then measure the inside
diameter.
Torque
Standard
C ompare the two values obtained
through measurement of main bear-
ing inside diameter with the outside
diameters of crankshaft journals to determine the oil clearance.
<Main bearing oil clearance>
Standard
0.072 ~ 0.142 mm
•
Connecting rod bearing clearance
Install the connecting rod bearing in
the connecting rod bearing cap, tight-
en the connecting rod cap bolts to the
specified torque, then measure the
inside diameter.
Torque
Standard
Compare the two values obtained
through measurement of connecting
rod bearing inside diameter with the
outside diameters of crankshaft pins
to determine the oil clearance.
Standard
0.049 ~ 0.119 mm
INSPECTION AND MEASUREMENT
30 kg . m
N 96.06 ~ N 96.108 mm
Limit
0.25 mm
28 kg . m
N 83.02 ~ N 83.092 mm
Limit
0.20 mm
- 70 -
EAMD060I