3) Wear
•
Assemble the connecting rod to the crankshaft and measure connecting rod big end side
clearance using a feeler gauge.
•
Assemble the connecting rod to the piston and measure connecting rod small end side
clearance.
•
If the measured values are beyond the limit, replace the connecting rod.
Limit
3.2.12. Fuel injection nozzle
•
Insert a seal ring and injection nozzle
on the cylinder head.
•
Measure the clearance between the
cylinder head bottom and nozzle tip. If
the measured values are beyond the
limit, replace the seal ring.
Standard
A
(Thickness of seal ring)
B
(Projection of nozzle)
0.5 mm
DE12T/TI/TIA
DE12TIS
1mm
3mm
3.4 ~ 3.5 mm 2.4 ~ 2.5 mm
INSPECTION AND MEASUREMENT
- 75 -
Fuel injection
연료분사 노즐
nozzle
실린더 헤드
Cylinder head
노즐 튜브
Nozzle tube
EQM8010I