Advertisement
●Reflector
Fix the reflector into position
facing the sensor with
3 x (Φ4x30mm) self-tapping
screws
Self-tapping screws
Hood fixing screw
58mm(2.28")
POLE MOUNT WITH BP-60A (Sold separately)
※Fit pole size : Outside dia.38mm(1.5") to 45mm(1.77").
●Sensor
①Insert 2 x oval countersunk head screws (M4x20) into the pole
bracket with a few turns.
②Hold a pole between the pole mounting plate and the pole
bracket and tighten the screws.
③Insert 2 x screws (M4x6) into the pole mounting plate with a
few turns.
④Fix the sensor mounting plate to the pole mounting plate.
③
④
Sensor mounting plate
(Remove it from the sensor body)
⑤Please follow the wall mount procedure after completing the above.
●Reflector
①Insert 2 x oval countersunk head screws (M4x20) into the pole
bracket with a few turns.
②Hold a pole between the pole mounting plate and the pole
bracket and tighten the screws.
③Fix the reflector unit to the pole mounting plate by 2 x oval
countersunk head screws (M4x20).
④Insert the push rivet into the lower hole in order to seal it.
Pole mounting plate
③
oval countersunk
head screws
Push rivet
④
※In case of indoor installation, the hood can be removed if it is not required.
①Unscrew 2 x fixing screws on the top of reflector and remove the hood.
②Remove push rivet.
③Invert the reflector with the hood fixing holes facing downwards and fix into
position with 2 x
(Φ4x30mm)
self-tapping screws
using the upper
and lower holes.
④Insert 2 x push
rivets into the
fixing screw holes
to cover these
holes.
127mm(5")
（note）In case of outdoor installation, please do not remove hood.
Pole bracket
①
②
Oval countersunk head
screws
Screws
Pole mounting plate
Pole bracket
①
②
Oval countersunk head
screws
Reflector
Hood fixing screws
①
Hood
Push rivet
②
Upside down
In case of back-to-back
（note）It's not possible to mount the reflector back
to back.
①Mount the first pole mounting plate.
②Pass through the second pole bracket under the
first pole mounting plate. and fix the second
pole mounting plate upside down.
※Please follow the same procedure of wall mount
after above.
Installation with BL-11 (Sold separately)
（note）It's not possible to mount the sensor on BL-11.
①Fix the BL-11to the wall by 2 x self-tapping
screws.
(Φ4x20mm) (using keyhole)
②Fix the reflector to the BL-11 by 2 x oval
countersunk head screws (M4x20).
③Insert the push rivet into the lower hole in
order to seal it.
Reflector
②
Screws
Push rivet
④
③
Self-tapping screws
Push rivet
④
①
Self-tapping
screws
③
196mm
(7.72")
BL-11
Advertisement
