Advertisement
① ② ③ ④ ⑤ ⑥ ⑦
＋
−
●
Voltage
Wire size
Note)
Maximum wiring distance when two or more sets are
connected is the value above divided by the number of
sets.
●Sensor
①Remove cover from
unit and slide the
mounting plate
upwards to detach
it.
②Pull the wire through on the installation site.
③Make one hole in the grommet on the mounting plate and
pull the wire through it.
Secure the plate with 2 x (φ4x30mm) self-tapping screws.
Pull the wire through the sensor body (back to front)
and attach it to the terminals on the sensor.
▼
▼
DC12V
DC24V
●
●
①②③④
●
①②③④
④When the wiring is exposed break knockouts (2 positions) on
the rear of the unit, pull the wire through as in the figure
and attach it to the terminals on the sensor.
⑤After wiring is completed, adjust alignment, attach cover
and check operation.
(Note : Sealing is not required around the unit due to
rain-proof construction.)
※The grommet is compatible with a wire of φ3mm (φ0.12")
to φ6mm (φ0.24") outer dia.
When a wire of more than φ6mm (φ0.24") outer dia. is
used, cut off the dotted line portion on the below figure using
pliers or the like.
Then use caulking to prevent insects from entering into the
unit.
③
｝
｝
①②③④
. .
｝
｝
①②③④
. .
｝
｝
｝
①②③④
Advertisement
