Unpacking And Set-Up (Freestanding Model) - Ferno SA-3BLP-01 Care & Use Manual

FREESTANDING GRILL UNPACKING AND SET-UP
The Ferno Freestanding & Built-in Grills arrives
almost fully assembled and requires only minor
assembly steps. Depending on the delivery
method, the Freestanding and Built-in Grills may be
palletized for ease of shipping and movement.
Shipping weight for either model is approximately
275-300 pounds.
WARNING
EXCESSIVE WEIGHT HAZARD
Use 2 or more people to move or install this unit.
Failure to follow this instruction can result in
personal injury.
CRATE & CARTON: HOW TO REMOVE THE CARTON
1. Cut the main strap holding the grill to the
pallet.
2. Remove the straps at the bottom of the
carton.
3. Lift off the carton.
4. With assistance, remove the grill from the
pallet and place in desired location.
INITIAL SETUP (Disregard side shelf related
instructions for Built-in Model applications)
1. Open the lid and cut all zip ties holding the
interior contents. Remove the side shelf
surfaces, side shelf frames, grill cover and
the small hardware and accessories box.
2. Ensure that the burner radiants have not
shifted during transit and are seated
properly
3. Place each of the side shelf insulators on
the brackets, making sure that all of the
holes line up.
4. Place the side shelf frame, with the pegs
facing up, on the bracket with insulators
and align all holes.
5. Using the screws and allen wrench from the
provided accessories box, screw the side
shelf frame to the brackets. Tighten all
screws, do not over-tighten.
6. Set the side shelf surface on top of the side
shelf frame with the holes facing down. The
side shelf surface holes will align with the
pegs on the side shelf frame.
7. Repeat on other side.
INTERIOR PACKAGING
Sturdy zip ties and straps are used to ensure
that your grill arrives at your home in the same
condition that it left our factory. MAKE SURE that
you have removed ALL zip ties before using your
grill.
Page | 8