Installations & Connections; Battery Installation - Ferno SA-3BLP-01 Care & Use Manual

BATTERY INSTALLATION

The small hardware and accessories box included
with your Ferno Grill comes with one (1) 9V battery
that provides the power for the electronic ignition
system and three (3) C Cell batteries for the
integrated LED lights in the handle. To install or
replace the batteries, follow these procedures.
9V BATTERY (FREESTANDING MODEL)
1. Locate the battery compartment under the
right side of the firebox, next to the gas line
fittings.
2. Insert your fingernail or flat edged tool into the
notch located on the side of the battery
cartridge nearest the tank shroud, pull towards
you and down to release.
3. Remove battery and insert or replace with a
new 9V battery in the orientation as depicted
on the cartridge.
4. Re-insert cartridge in same orientation as it was
removed (it cannot be installed backwards).
9V BATTERY (BUILT-IN MODEL)
INSTALLATIONS & CONNECTIONS
Locate the battery compartment on the lower right
side next to the drip tray opening and follow the
procedure described above.
C CELL BATTERIES
1. Unscrew battery cap counterclockwise on the
right side of the handle (with the black button).
2. Remove the battery cartridge.
3. Remove batteries and insert or replace with 3
new C Cell batteries in the same orientation as
depicted on the outside of the cartridge. All
batteries must be new and/or fully charged –
do not mix new and used batteries or batteries
of different types.
4. Insert cartridge back into handle and turn
clockwise until snug. Do not overtighten.
The LED lighting in the grill lid occasionally requires
a simple cleaning. Inside the grill lid are two LED
lights, each covered by a thick piece of glass. To
clean grease build up use a Scotch Bright type
material with some dish soap and scrub vigorously.
Page | 19