Lubricating The Chain And Jack Screw - Ferno SA-3BLP-01 Care & Use Manual

LUBRICATING THE CHAIN & JACK SCREW
The chain and jack screws that make it possible for
the burners to be raised and lowered inside of your
Ferno Grill leave the factory with enough
lubrication to last for many years. If at some point
the grill begins to squeak when raising or lowering
the burners then it may be time to consider
lubricating the chain and jack screws by following
these steps.
Freestanding Model:
1. Remove both side shelf surfaces.
2. Locate the opening on the top front edge
on the left side of the grill.
3. Through the opening, you will see the jack
screw threads that need to be lubricated.
4. Turn the firewheel counterclockwise until
the burner bed is fully lowered.
5. Using grease and a brush, lubricate the
entire length of the jack screw.
6. To lubricate the right side, remove the right
front quarter panel by first lowering the
burners to the lowest position and
unscrewing the five (5) screws holding it in
place. Gently maneuver it free of the grill.
7. Using grease and a brush, lubricate the
entire length of the jack screw and the
exposed section of chain.
8. Turn the wheel clockwise in ½ turn
increments and on each turn, apply
additional lubricant to the newly exposed
section of the chain.
9. Once the burner bed is fully raised, apply
lubricant to the newly exposed portion of
the jack screw.
Built-in Model (EXCESSIVE WEIGHT HAZARD, USE 2
PEOPLE TO PERFORM THE FOLLOWING STEP):
1. Very carefully slide the grill out of the
enclosure enough to reveal the lubrication
points (NO MORE THAN 6 INCHES).
2. On the left side of the grill, locate the jack
screw and lubricate according to the
Freestanding Model instructions above.
3. On the right side lubricate the jack screw
and chain according to the Freestanding
Model instructions above.
Page | 18