Pre-Grill Checklist - Ferno SA-3BLP-01 Care & Use Manual

BEFORE YOUR FIRST USE
1. Make sure ALL packing materials have been
removed from the interior of the grill, and that
ALL zip-ties holding contents in place have been
removed.
2. Make sure the fuel lines have been connected
per instructions in the section entitled 'Gas
Connections'.
3. Make sure that you have made all electrical
connections and/or installed fresh batteries.
4. A qualified plumber has performed a leak test
on all the gas fittings that supply fuel to the
grill.
AT EACH NEW SEASON
At the start of each new grilling season, the grill
should be inspected. Remove the cooking grates,
both upper and lower radiants, check the burners,
the burner venturis, the orifices, and the valves for
any apparent obstructions. Spiders and other small
insects often nest in these areas and can disrupt air
and gas flow and can cause damage to the grill or
personal injury. Also check all hoses and fittings for
damage.

PRE-GRILL CHECKLIST

CHECKLIST BEFORE EACH USE
Always make sure that:
1. You do NOT smell gas BEFORE you light the
2. The cooking area and cooking grates are free
3. The control knobs turn freely.
4. The burners are seated properly.
5. If you are using a Propane cylinder, that the
6. If you are using a Propane cylinder, be sure that
7. If you are using Natural Gas (NG), be sure that
8. Wind is not blowing too strongly into the grill.
grill. If you smell gas, shut everything OFF and
call a qualified plumber to check for leaks. See
also 'Leak Test Procedure' in the section
entitled 'Final Checks'.
from combustibles that could ignite.
connections have been leak tested. See also
'Leak Test Procedure' in the section entitled
'Final Checks'.
the gas valve has been turned ON before
attempting to light the grill.
the main gas valve has been turned ON before
attempting to light the grill.
Page | 10