Gas Connections; Liquid Propane (Lp) - Ferno SA-3BLP-01 Care & Use Manual

Built-in & freestanding grill
Table of Contents

Advertisement

This grill has been factory pre-set to use either
Propane Gas (LP) or Natural Gas (NG). It is critical
that the gas you use matches the gas that the grill
has been set up for. For the Freestanding Model,
you can verify this by checking the rating plate
mounted on the outside rear of the tank shroud
and the inside rear of the tank shroud. For the
Built-in Model, the rating plate is located on the
bottom of the Drip Tray and on the lower left side
of the grill body.
Ensure that the gas supplied meets minimum
pressure requirements, as shown below, under full
load:
Fuel
WC max
NG
7 inches
LP
14 inches
WATER COLUMN REQUIREMENTS
Both the regulator and the manifold orifices have
been tuned for the type of gas specified on the
rating plate. All installation and all installation
parts must conform to local codes with the
National Electrical Code, ANSI Z223.1/NFPA 70
latest edition and the National Fuel Gas Code, ANSI
Z223.1/NFPA 54 in the U.S
LIQUID PROPANE GAS (LP)
Grills set up for LP gas come equipped with an LP
hose/regulator assembly for connection to a
standard 20lb LP gas cylinder. All fittings necessary

GAS CONNECTIONS

WC min
4 inches
11 inches
to attach the hose assembly to the grill are
included.
BULK TANK LP
Some residences are permanently plumbed with LP
connections, such as those in line with a bulk
propane cylinder. When this is the case, then the
4/11 regulator supplied with your grill must be set
for the proper gas type (PROPANE). To convert,
unscrew the cap on the pressure regulator, then
unscrew and flip the plunger. Screw it in and then
carefully screw the cap back in and tighten.
LP CYLINDER REQUIREMENTS
The LP cylinder must be constructed and marked in
accordance with the specifications for LP cylinders
from the US Department of Transportation (DOT)
and designed for use with a Type 1 system only.
Cylinders in freestanding grills must be seated
completely down in the cylinder retention system
(tank holder) to avoid accidental movement.
Page | 22

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sa-3bng-01

Table of Contents