Ferno SA-3BLP-01 Care & Use Manual page 17

4. Pull out cotter pins from both ends of each
burner. Remove the RIGHT burner first by
lifting slightly up and to the left and then up
and out. Follow the same method to remove
the CENTER and then LEFT burners.
Inspect all burner ports (holes) ensuring that they
are not clogged or do not become clogged during
the cleaning process. Clear any clogged ports with
a paper clip. DO NOT use a wooden tooth pick as it
can break off inside the port.
Finish the cleaning process by tilting the burner
upright, with the venturi opening facing down.
Shake the burner so that all remaining debris inside
falls out from the venturi opening. Be careful not to
disrupt or change the air flow setting created by
the air shutter and its associated locking screw.
WARNING
PROPER PLACEMENT OF EACH BURNER IS
CRITICAL. AFTER CLEANING THEY MUST BE
CENTERED ON THE BRASS ORIFICE, RESTING
LEVEL WITHOUT ANY ROCKING. REPLACE THE
COTTER PINS TO SECURE THE BURNER.
FAILURE TO MEET THESE CONDITIONS MAY
CAUSE A VERY DANGEROUS CONDITION THAT
CAN CAUSE PERSONAL INJURY AND PROPERTY
DAMAGE.
TO RE-INSTALL THE BURNERS
1. Reverse the removing burner instructions as
listed above in steps 1-4 but note that the left
burner (longest burner) must be installed first,
followed by the center burner and finish with
the right burner.
2. When installing the burners, verify that the
burner inlet (gas inlet opening) sits over the
appropriate orifice. This can be done by viewing
the burner inlets from the REAR of the grill
(Freestanding Model) through the ventilation
cutouts.
3. Finally, check all the burners for proper
operation. Make sure the burner control knobs
turn freely and completely through their full
range.
Page | 17