Table of Contents
Advertisement
supply system must be arranged for vapor
withdrawal.
5. The pressure regulator and hose assembly
supplied with this outdoor gas appliance (LP
models only) must be used. Original and
replacement pressure regulator and hose
assemblies must be those specified by Ferno
Grills for connection with a cylinder connecting
device identified as Type I by the ANSI Z21.58-
2018.
6. The propane-gas cylinder valve must be
equipped with a cylinder connection coupling
device, described as Type I in the standard
definition as defined in paragraph 5 above. This
device is commonly described as an Acme
thread quick coupler.
7. If the propane-gas cylinder comes with a dust
cap, place the dust cap on the cylinder valve
outlet whenever the cylinder is not in use.
QUICK COUPLER OPERATION
1. To connect the regulator/hose assembly to the
propane-gas cylinder valve fitting, press the
hand nut on the regulator over the Acme
thread fitting on the cylinder valve. Turn the
hand nut clockwise to engage the threads and
tighten until snug. Only cylinders marked
"propane" can be used.
2. To disconnect turn the hand nut counter
clockwise until
detached.
3. IMPORTANT:
Before using the
unit, and after
each time the
cylinder is
removed and
reattached, check
the hose for wear
(see paragraph 1)
and check all
connections for
leaks. Turn the grill burner control knobs OFF
and open the main cylinder valve, then check
connections with soapy water. Repair any leaks
before lighting the grill.
4. CAUTION: ALWAYS turn the propane cylinder
main valve OFF after each use, and before
moving the grill and cylinder or disconnecting
the coupling. This valve must remain closed and
the cylinder disconnected while the grill is not
in use, even though the gas flow is stopped by a
safety feature when the coupler is
disconnected.
5. CAREFULLY inspect the hose assembly each
time before the gas is turned on. A cracked or
frayed hose must be replaced immediately.
6. If the grill is stored indoors, the cylinder must
be disconnected and removed. Disconnected
cylinders must be stored outdoors, out of the
reach of children, with threaded valve caps
tightly installed, and must not be stored in a
building, garage, or any other enclosed area.
INSTALLING AND CONNECTING A LP TANK
For the Built-In Model, connections will be the
same, only the location of the tank will be different
(see 'TYPICAL PROPANE HOOK-UP' on page 21).
1. Open tank door by pulling the handle on the
left side of the tank shroud door.
2. Place a single tank on the lower ring that is
affixed to the door so that the tank fits inside of
the ring.
3. Rotate the tank to where the outlet is facing
the warning label stating, "Point Tank Valve
Here".
4. Remove any plastic cover from tank outlet.
5. Attached Acme quick thread coupler to tank
outlet (as described above).
6. Close tank door and press until latched.
Page | 24
Advertisement
Table of Contents
Troubleshooting
