Create A Scene In Bank B (Double Control Mode); Crossfade Between Bank A And Bank B (Double Control Mode) - SHOWTEC ColorCue 4 User Manual

ColorCue 4

Create a Scene in Bank B (Double Control Mode)

01) Make sure that the device is in double (24-fixture) control mode. See 6.4. Control Modes on pages
18–19 for more information.
02) Set the BANK B master fader (L) to 0, if you do not want to output the scene live while you are
creating it. If you set the BANK B master fader (L) to any other value, any changes you make will be
output live.
03) Press one or more FIXTURES buttons (25)–(48) to select the fixture(s) you want to control. The LED(s) on
the button(s) will light up. If you want to have the same color for all connected fixtures, press all
FIXTURES buttons (25)–(48). If you want to have different colors for each of the connected fixtures,
select only one fixture at this step. You can also select multiple fixtures, if you want to have one color
on more than one fixture. The selected fixtures will be highlighted on the display.
04) Slide the BANK B fixtures faders (25)–(48) to adjust the light intensity of the connected fixtures,
selected in step 3. The LEDs above the fixtures faders will light up.
05) Make sure that the color selection mode is enabled. See 6.5.1.1. Color Selection Mode on page 19.
06) Turn the controls (E)–(J) to select the desired color. The available colors are red, green, blue, white,
amber and UV. Turning the control clockwise will increase the color intensity. The display will show the
color value in the range 0–255. If you want to clear a selection, press the CLEAR button (68).
07) If you want to select different colors for different fixtures, press the FIXTURES button(s) (25)–(48) once
again to cancel the selection of the fixture(s) you have made in step 3. The LED(s) on the button(s)
will turn off. Do not do steps 7 and 8, if you have selected the same color for all connected fixtures.
08) Repeat steps 3–6 to select colors for the remaining fixtures.

Crossfade between Bank A and Bank B (Double Control Mode)

01) Create a scene in BANK A. Refer to 6.6.1. Creating a Scene in Bank A on page 21.
02) Slide the BANK A master fader (K) to 100 to output the scene and at the same time slide the BANK B
master fader (L) to 0.
03) Create a scene in Bank B. Refer to 6.6.2. Creating a Scene in Bank B on page 22.
04) Slide the BANK B master fader (L) to 100 to output the scene and at the same time slide the BANK A
master fader (K) to 0.
You can continue crossfading between Bank A and Bank B by sliding the master faders (K) and (L) up
and down, or you can repeat steps 1–4, each time creating a new scene in Bank A and Bank B.
Product code: 50706
22
Fig. 17