Table of Contents
Advertisement
ColorCue 4
●
Approach 1:
If you want to note down the starting DMX addresses, select one fixture first, change
the LEDs type and then select the next fixture. Thus, each time the screen will display
the correct starting DMX address of each fixture.
●
Approach 2:
If you select all fixtures first and then set the LEDs type, only the starting DMX address
of the last fixture will be displayed on the screen.
There are no functional differences between Approach 1 and 2.
MIDI Address Setup
In setup mode press the UP/DOWN buttons (49)/(52) to assign the MIDI address of the ColorCue 4. The
selection range is 1–16. Refer to 6.10. MIDI Implementation Chart on page 32 for more information.
Control Modes
The device has 2 control modes:
●
double (24-fixture) mode, and
●
single (48-fixture) mode.
Press the FIXTURES button (54) to toggle between double and single control mode. In single mode the LED
on the button will light up in red and in double mode in green.
Double (24-Fixtures) Mode
In double (24-fixtures) mode you can control up to 24 fixtures. You can create scenes in Bank A and
Bank B. In manual operating mode you can crossfade between the scenes in Bank A and Bank B.
In double (24-fixtures) mode:
●
The FIXTURES buttons and faders (01)–(24) control Bank A scene values of the connected up to 24
fixtures
●
The FIXTURES buttons and faders (25)–(48) control Bank B scene values of the connected up to 24
fixtures.
●
The BANK A master fader and flash button (K) control the output of Bank A.
●
The BANK B master fader and flash button (L) control the output of Bank B.
Single (48-Fixtures) Mode
In single (48-fixtures) mode you can control up to 48 fixtures. You can create single scenes. It is not
possible to work with Bank A and Bank B scenes in this mode. You can transition between the scenes
without crossfading.
Product code: 50706
18
Fig. 12
Fig. 13
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorCue 4 and is the answer not in the manual?