The F value and shutter speed flash when you press and hold the shutter
button halfway down.
The exposure is incorrect. Correct the exposure (pages 39, 41).
•
The image is too dark.
You are shooting a subject with a light source behind the subject. Select the metering mode
•
(page 40) or adjust the exposure (page 41).
The brightness of the screen is too low. Adjust the brightness of the LCD backlight/finder
•
backlight (page 80).
The image is too bright.
You are shooting a spotlighted subject in a dark location such as on a stage. Adjust the
•
exposure (page 41).
The brightness of the screen is too bright. Adjust the brightness of the LCD backlight/finder
•
backlight (page 80).
The image colors are not correct.
Picture Effect function is activated. Cancel the Picture Effect function (page 63).
•
Noise appears in the image when you view the screen in a dark place.
The camera is attempting to increase the visibility of the screen by temporarily brightening
•
the image under conditions of low illumination (Auto brightness monitoring). There is no
effect on the recorded image.
Vertical streaks appear on the screen.
•
This is the flicker phenomenon. This is not a malfunction (page 61).
When the setting of the power supply frequency is wrong, flicker may be generated. Check
•
the setting of [Flicker Reduction] in the
The eyes of the subject come out red.
Activate the red eye reduction function (page 50).
•
Shoot the subject at a distance closer than the recommended shooting distance using the flash
•
(page 50).
Light the room and shoot the subject.
•
Zebra stripes appear on the screen.
•
[Zebra] is set to [On] (page 42). If it is not necessary, cancel it.
Grid lines appear on the screen vertically and horizontally.
[Grid Line] is set to [On] (page 60). If it is not necessary, cancel it.
•
(Setup) menu (page 61).
111