3. Slide the rotor (fig. 4-3/7) onto the hub while per-
forming a rotary motion.
4. Check if the rotor can be turned easily and if the
pawls lock.
5. Grease the bearings and the inner surface of both
end caps (fig. 4-3/1, 8).
6. Put on both end caps (fig. 4-3/1, 8) and push them
in by hand.
Caution: The shorter end cap must be attached on the
drive side.
Closing Steps
Mount the cassette.
Mount the brake disc.
®
SPLINE
Technical Manual
Link
see instructions of the manufacturer
44