Removing A Single Spoke On The Front Wheel [Non-Slotted Hub] - DT SWISS ROAD 2013 SPLINE RC 38 Technical Manual

5.5.3 Removing a Single Spoke on the Front Wheel [Non-Slotted Hub]

Preparatory Steps
Dismount the wheel.
Dismount the tire and if necessary the tube and the rim tape.
Clean the wheel and check for damages.
Loosen the spoke.
1. Remove the adapter.
a) Put the axle holder (see
vice.
b) Clamp the adapter on the side of the spoke
which needs to be replaced into the axle hol-
der.
c) Pull the wheel upwards using both hands.
d) Remove the adapter from the vice.
2. Slide the spoke with the nipple out of the rim.
3. Slide the spoke out of the hub.
4. Slide a new spoke through the hub.
chap.5.2, p.49) into a
®
SPLINE Technical Manual
Link
chap.5.5.1, p.58
62