Putting on the Ratchet System
1. Clean the outer and the inner toothing of the star
ratchets using DT Swiss special grease.
For an optimal functionality, a thin layer of grease
is sufficient.
2. Grease the toothing of the rotor using DT Swiss
special grease.
3. Grease the bearing on the drive side using multi-
purpose grease.
Caution: There must not get grease onto the
toothing of the star nut.
4. Put on the spacer (fig. 4-1/9) and the first spring
(fig. 4-1/10).
The big diameter of the spring must be placed on
the bearing of the hub.
®
SPLINE
Technical Manual
26