Maintenance Of The Rear Wheel Hub [Three Pawl System] - DT SWISS ROAD 2013 SPLINE RC 38 Technical Manual

4.7

Maintenance of the Rear Wheel Hub [Three Pawl System]

figure 4.6: Overview Three Pawl System
1 adapter left
2 ball bearing
3 axle
Preparatory Steps
Remove cassette.
Required Material
multi purpose grease
service kit 3 pawl system
NOTE
Risk of damage of the adapters!
To avoid damages, only use grind clamping jaws, aluminium clamping jaws or special tools to clamp the
adapters.
Removing the Adapter, Rotor and Spacer
1. Clamp the right adapter (fig.4.6/8) into a vice.
2. Pull off the wheel, respectively the hub. Take care
that the rotor (fig.4.6/7) does not fall off.
3. Clamp the left adapter (fig.4.6/1) into a vice.
4. Pull off the wheel, respectively the hub.
4 hub shell
5 ring nut
6 spacer
Specification
-
®
SPLINE Technical Manual
7 rotor
8 adapter right
Link
see instructions of
the manufacturer
Amount
as required
as required
42