DT SWISS ROAD 2013 SPLINE RC 38 Technical Manual page 31

5. Put on both star ratchets (fig.4.4/11) and the se-
cond spring (fig.4.4/10).
The small diameter of the spring must be placed
on the star ratchet.
Putting on the Rotor and the Adapters
1. Grease the rotor and put it onto the hub.
2. Check if the rotor can be turned easily and if the
star ratchets are locking.
3. Grease both bearings and the contact surface of
the adapters (fig.4.4/1/13).
4. Put both adapters (fig.4.4/1/13) onto the hub.
Note: The shorter adapter must be placed on the drive
side.
®
SPLINE Technical Manual 30