Plastic Rear Vent And Fin - HP 15-fb0 Series Maintenance And Service Manual

8. Remove the touchpad (2).
To install the touchpad, reverse this procedure.

Plastic rear vent and fin

To remove the plastic rear vent and fin, use this procedure and illustration.
Table 6-12 Plastic rear vent and fin descriptions and part numbers
Description
Dummy fin
Plastic rear vent
Before removing the plastic rear vent and fin, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the fan assembly (see
5. Remove the system board with the heat sink installed (see
Remove the plastic rear vent and fin:
Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
Fan assembly on page
36).
45).
System board on page
Plastic rear vent and fin
Spare part number
N13308-001
N13307-001
36).
50).
55