Download Print this page

Billion BiPAC 7300GX Quick Start Manual page 7

3g/adsl2+ wireless router
Hide thumbs Also See for BiPAC 7300GX:

Advertisement

Easy Sign-On:
User just installs all of cables and uses the browser to surf Internet. At this time, the Easy
Sign-On WEB GUI will be popped up and request you to input some basic information. After this,
you can surf Internet right away.
Troubleshooting
1. None of the LEDs are on when you turn on the router.
Check the connection between the adapter and the router. If the error persists, you may have
a hardware problem. In this case you should contact technical support.
2. You have forgotten your router login and/or password.
Try the default login and password, please refer to Chapter 3. If this fails, you can restore
your router to its factory settings by holding the Reset button on the back of your router over 6
seconds then release it.
3. Can't ping any PCs on the LAN.
Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC
connected. If it is off, check the cables between your router and the PC. Make sure you have
uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet
mask are consistent between the router and the workstations.
4. Frequent loss of ADSL linesync (disconnections).
Ensure that all other devices connected to the same telephone line as your router (e.g.
telephones, fax machines, analogue modems) have a line filter connected between them and
the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified
and licensed electrician), and ensure that all line filters are correctly installed and the right
way around. Missing line filters or line filters installed the wrong way around can cause
problems with your ADSL connection, including causing frequent disconnections. If you have
a back-to-base alarm system you should contact your security provider for a technician to
make any necessary changes.
5. 3G interface can not work.
Check the 3G LED on the front panel. The LED should be on for the 3G data card connect
successfully. Because this device is not support hot plug function in 3G card slot. Please
power off the device and re-install the 3G data card at first then power on the device again.
And also check your 3G data card had been list at our support list.
Product Support and Contact Information
Most problems can be solved by referring to the Troubleshooting section in the User's Manual.
If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer
where you purchased this product.
Contact Billion
WORLDWIDE:
http://www.billion.com
Billion BiPAC 7300GX 3G/ADSL2+ Wireless Router
5

Advertisement

loading