Billion BiPAC 7800(N)X(L) 3G/4G LTE (Wireless-N) (VPN) ADSL2+/ Fibre Broadband Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON CD-ROM.
Page 3
Quick Start Guide Package Contents BiPAC 7800X 3G/4G LTE ADSL2+ VPN / Fibre Broadband Router CD containing the on-line manual RJ-11 ADSL/ telephone cable Cat. 5e STP Ethernet (RJ-45) cable Power adapter Quick Start Guide Splitter/ Micro-filter (Optional) Do not use the router in high humidity or high temperatures.
Billion BiPAC 7800(N)X(L) 3G/4G LTE (Wireless-N) (VPN) ADSL2+/ Fibre Broadband Router Hardware Overview The Front LEDs Lit red when WAN port fails to get IP address; lit green when WAN port BiPAC 7800NX(L) Only When the system is ready, gets IP address successfully. Unlit the LED will be lit green;...
Page 7
Quick Start Guide In following installation, wireless antennas are only used for BiPAC 7800NX(L). 1. Power Connection Plug the supplied power adapter to the wall jack and the other side to the router. Please note that the plug type may differ according to different country. 2.
Page 8
Billion BiPAC 7800(N)X(L) 3G/4G LTE (Wireless-N) (VPN) ADSL2+/ Fibre Broadband Router 2) The USB 2.0 port supports 3G/4G LTE modem connectivity :Users can conveniently access Internet via 3G/4G LTE, eliminating the limitations of the wired network. This solution also employs an auto fail-over feature to ensure always-on connectivity for SOHO users.
Page 9
Quick Start Guide 6. Splitter/ Micro-filter Connection The Splitter / Micro-filter are important for ADSL installation, they help direct high-frequency signals to the ADSL modem & low frequency signals to the telephone or other analogue device to prevent inter-modulation distortion & get good speed/stable ADSL sync rate.
Page 10
Billion BiPAC 7800(N)X(L) 3G/4G LTE (Wireless-N) (VPN) ADSL2+/ Fibre Broadband Router 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem.
Need help?
Do you have a question about the BiPAC 7800X and is the answer not in the manual?
Questions and answers