Misc Configuration; Diagnostic Test - Billion BiPAC 7100S User Manual

Adsl modem/router with 10/100m lan port

Hide thumbs Also See for BiPAC 7100S:

Table of Contents

3.4.3.7.8 MISC Configuration

HTTP server access: Default at Restricted.

HTTP server port: Default at 80.

FTP server: Default at Enabled.

TFTP server: Default at Disabled.

DMZ: Regarding the DMZ Host, it is a local computer exposed to the Internet. Therefore, an incoming

packet will be checked by NAT algorithms in the ADSL Router, then passed to the DMZ host when the

packet is not sent by hacker or not limited by the virtual server list.

DMZ HOST IP: Enter the IP address of the DMZ host.

DHCP Relay: Default at DHCP Server.

DHCP Target IP: Default is 0.0.0.0

IGMP Proxy: Default at Disabled.

PPP Half Bridge: Default at Disabled.

PPP reconnect on WAN access: Default at Disabled. Select Enabled if you want to automatically re-

establish the PPPoE/PPPoA session when disconnected by ISP.

As soon as you enter the test program, all tests will run automatically to diagnose the connection status of

the device.

Chapter 3 Configuration

Table of Contents