Bosch Rexroth CS351 Manual page 8

60/108 Bosch Rexroth AG
General safety instructions
NOTE
NOTE indicates a situation which, if not
avoided, can result in minor or moderate
damage to equipment.
If this information is not obser-
ved, operation may be impaired.
Adhere to the following instructions
General instructions
Observe the valid regulations for occupa-
tional safety and environmental protection
for the country where the product is used
and at the workplace.
Only use Rexroth products that are in per-
fect technical condition.
• Check the product for visible defects
such as cracks in the housing or missing
screws or seals.
Do not change or modify the Compact Sys-
tem under any circumstances.
Only use the product within the perfor-
mance range indicated in the technical
data.
Persons who assemble, operate, disassem-
ble or maintain Rexroth products must not
do so while under the influence of alcohol,
other drugs or pharmaceuticals that may af-
fect their ability to respond.
Do not expose the Compact System to un-
acceptable mechanical loads under any cir-
cumstances. Never use the product as a
handle or step. Do not place any objects on
it.
Observe the local, system-specific regula-
tions and requirements; proper use of tools,
lifting, and transport equipment; as well as
the relevant standards, provisions, and oc-
cupational safety regulations.
CS351 | 3609929B45/2014-09
During assembly
Make sure the system component in ques-
tion is depressurized and de-energized be-
fore assembling the product or connecting
or disconnecting plugs. Protect the system
from being switched on.
Lay cables and lines in accordance with the
permissible bending radiuses so that they
cannot be damaged and no one can trip
over them.
Before commissioning, make sure that all
the connection gaskets and plugs are in-
stalled correctly to ensure that they are leak-
proof and fluids and foreign bodies are pre-
vented from penetrating the product.
During commissioning
Let the product acclimate itself for several
hours before commissioning, otherwise
condensation may form in the housing.
Condensation can damage the compact
system when it is switched on.
Make sure that all electrical connections are
either assigned or covered. Commission
the product only if it is installed completely.
During operation
Only allow persons who are authorized by
the operator to access the system's direct
operating area. This also applies when the
system is not in operation.
In case of an emergency, fault or any other
anomalies, switch the system off and pro-
tect it from being switched on again.