Bosch Rexroth CS351 Manual page 36

88/108 Bosch Rexroth AG
Commissioning
Removing the front cover
You can remove the front cover to improve
access to the interfaces.
1. Release and open the front cover.
2.
1.
Fig. 28: Releasing and opening the front co-
ver
2. Slide the left and right axle pins in and
remove the front cover.
2.
1.
Fig. 29: Removing the front cover
1.
CS351 | 3609929B45/2014-09
Assembly:
1. Push the axle pins in and insert the front
cover.
2. Release the axle pins – both axle pins
must engage in the front cover.
Commissioning the Compact System
Proceed as follows to commission the
Compact System:
1. Install all of the required interface modu-
les
– Release and remove the front cover
(see page 88).
– Slide the respective module in.
– Secure the module.
2. To operate the integrated computer
unit, connect an USB mouse and key-
board (connectors X3U6 – X3U8) as
well as a monitor (XDVI 2) (optional).
Devices and connection cables are not
included in the delivery of the Compact
System.
3. Connect the Compact System to the
external peripherals (e.g. partner cont-
roller or external TFT display).
4. Connect the emergency OFF equip-
ment, if necessary.
5. Check whether all module slots are
closed by modules or dummy panels.
6. Lay all the connection cables through
the cable duct strip:
– Open both bolts and remove the front
part of the cable duct.
– Insert all of the cables connected in-
side the front cover in the cable duct.
– Assemble the front part of the cable
duct.
7. Assemble the front cover.
8. Close and lock the front cover.