Figure 2-4 Installing The Probe And The Wedge On The Scanner - Olympus COBRA User Manual

DMTA-20006-01EN, Rev. B, February 2014
d) Remove excess couplant.
5. Insert the inner probe-holder arm pin into the mounting hole in the wedge (see
Figure 2-4 on page 24).
Couplant tube
Outer probe-holder-arm
Outer probe-holder arm

Figure 2-4 Installing the probe and the wedge on the scanner

6. Reinstall the outer probe-holder arm:
a) Engage the outer probe-holder-arm pin in the other mounting hole in the
wedge.
b) Ensure that the outer probe-holder arm is parallel to the inner probe-holder
arm.
c) Tighten the outer probe-holder-arm screw.
7. Ensure that the probe and wedge assembly is free to rotate around the pins
without presenting lateral movement.
8. Adjust the length of the exposed cables and tubes (see section "Adjusting the
Length of Exposed Cables and Tubes" on page 26).
9. Clip the probe cable and couplant tube on the cable-management posts.
Make sure that you are inserting the probe cable in the bigger diameter groove in
order to not damage the outer shield.
24 Chapter 2
Probe
screw
Inner probe-holder arm pin
Probe holder
Apply couplant
Wedge
Mounting hole
Outer probe-holder-arm pin