DMTA034-01EN, Rev. B, March 2014
6.
Remove the yoke, probe holder, and probe assembly from the scanner.
7.
Using a hexagonal key, on the side of the yoke, remove the screw that holds the
yoke parts together (see Figure 2-13 on page 32).
Figure 2-13 The screw that holds the yoke parts together
8.
Using a cross-headed screwdriver, unscrew the screws that hold the probe on the
wedge (either 2 or 4 screws, depending on the model), and then remove the probe
from the wedge (see Figure 2-14 on page 32).
32
Chapter 2
Use a hexagonal
key to unscrew.
Use a cross-headed screwdriver to
unscrew the 2 or 4 screws
Figure 2-14 Removing the probe from the wedge