Figure 2-29 The Screw That Holds The Yoke Parts Together; Figure 2-30 Removing The Probe From The Wedge - Olympus GLIDER User Manual

DMTA029-01EN, Rev. E, December 2017
Figure 2‑29 The screw that holds the yoke parts together
7. Using a cross-head screwdriver, unscrew the four screws that hold the probe on
the wedge, and then remove the probe from the wedge (see Figure 2-30 on
page 36).
8. Install the new probe on the wedge.
36 Chapter 2
Figure 2‑30 Removing the probe from the wedge