Installing A Probe And A Wedge In A Probe Holder; Figure 1-3 Engraving On The Frame Bar - Olympus HST-Lite User Manual

3. Reassemble the scanner.
1.2

Installing a Probe and a Wedge in a Probe Holder

To install a probe and a wedge in a probe holder
Before installing a new probe into a probe holder, make sure that there is enough
couplant between the probe face and the wedge.
1. Apply couplant on the probe face (see Figure 1-4 on page 12).

Figure 1-3 Engraving on the frame bar

DMTA-20045-01EN, Rev. A, October 2012
Engraving
corresponding to
the wedge model
HST-Lite Scanner 11