Assembling The Scanner; Installing A Probe And Wedge In A Probe Holder; Figure 1-2 Pulling The Fork Arm Away From The Probe Holder - Olympus HST-X04 User Manual

DMTA020-01EN, Rev. C, March 2014
1.2

Assembling the Scanner

This section presents the assembly procedures for the HST-X04 scanner, which
include installing a probe and wedge in a probe holder, installing and adjusting a
probe holder, and installing the Mini-Wheel encoder.
1.2.1

Installing a Probe and Wedge in a Probe Holder

To install a probe and wedge in a probe holder
1. On the side of the fork, unscrew the wing screw enough so that you can pull the
fork arm away from the probe holder (see Figure 1-2 on page 12).

Figure 1-2 Pulling the fork arm away from the probe holder

2. Install the probe and wedge between the two fork arms and push the fork arm in
order to place the arm guiding pin into the wedge side hole.
Before installing a new probe into a probe holder, make sure there is enough couplant
between the probe face and the wedge.
3. Screw the wing screw until it holds the fork arm tight against the holder.
12 Chapter 1