Table of Contents
Advertisement
BPI-G1 Simple Code Firmware programming manual
BPI-G1 Simple Code Firmware programming manual
BPI-G1 Simple Code has two sets of firmware. We divided these two sets of firmware from the host firmware and firmware.
Host is an ap can use mobile phones and laptops direct link. The slave is a sta, is to link the router to link with mobile
phones and laptops.
Firmware programming steps:
Install the burner software.
BPI-OPENDEBUGGER three burning software are:
1.
JlinkARM Download:http://www.segger.com/jlink-software.html
2.
unifalsh Download：http://www.ti.com.cn/tool/cn/uniflash
3.
SmartRF Studio 7 Download：http://www.ti.com/tool/smartrftm-studio
4. Writer's programming software package we can extract the compressed firmware firmware get burned software shown:
BPI open debugger board writer and computer links
links good computer will prompt to install the driver shown :( Note: The picture is not completely installed drive, install a
good look at all of the drivers burner BPI-OPENDEBUGGER Writer Manual)
55
Advertisement
Table of Contents
