Table of Contents
Advertisement
Quick start of TI CC2530
8. Next, another a G1 programming development board. Choose from the list of items RouterEB
9. Another is a G1 and BPI OPENDEBUGGER connection. After connecting, click the CC Debugger interface again next
reset button, look at the status light is green, if not green, check the power supply G1 or G1 with OPEN DEBUGGER
the cable is properly
10. Click on the icon to download the program debug button on the device and enter debug mode. Figure
11. Click Debug Step Out button on the column, enter the full speed
50
Advertisement
Table of Contents
