Table of Contents
Advertisement
Quick start of TI CC2530
If the drive is normal, then check the G1 and Open debugger connection is normal. After the G1 to power, press the CC
Debugger interface open debuger reset button next.
If the connection is normal, then the status light next to the CC Debugger interface will turn green, if it is red or other colors,
please check whether it is normal or electricity on the G1 G1 is properly connected and Open Debugger.
Modifications to adapt the code for G1
1. Open the file C:\Texas instruments\ZStack-CC2530-2.5.1a\Components\hal\target\CC2530EB\hal_board_cfg.h, jump
to about 61 lines, will be as
2. Open the file C:\Texas Instruments\ZStack-CC2530-
2.5.1a\Components\mac\low_level\srf04\single_chip\mac_radio_defs.c，jump to about 300 lines, will be as
Modified to
46
Advertisement
Table of Contents
