Quick Start Stm32F103Cb - Banana Pi BPI-G1 Manual

Quick Start STM32F103CB
Quick Start STM32F103CB
Download and install the following software：
IAR EWARM (the software with the IDE compiler CC3200 is the same, if already installed, then the direct use,
otherwise the installation yourself, we recommend using IAR EWARM 7.2 or later)
Go https://github.com/mark-legend/bpi_g1_stm32_simpleled download SimpleLed
G1 connection BPI open debugger board
BPI open debugger check whether the software and hardware are connected
BPI Open debugger connected to the PC, and check whether the drive is installed, if you can not identify, install
JLinkARM，which comes with software drivers. If you can identify that, please give G1 powered.
Compile, download and debug routines SimpleLed
52