Quick Start Of Ti Cc2540/1 - Banana Pi BPI-G1 Manual

Quick start of TI CC2540\/1
Quick start of TI CC2540/1
The following operations are by CC2540 prevail, if G1 above your hands BLE chip CC2541, so in some way, your own
modifications by CC2541.
Download and install the software
Download and install the following software：
BLE Stack（Recommends using version 1.3.2, can go to google search to） ault installation folder C:\Texas
Instruments\BLE-CC254x-1.3.2
IAR EW8051（Please install the software on their own, we recommend using IAR EW8051 8.1).
G1 connection BPI open debugger burn board
BPI open debugger check whether the software and hardware are connected.
BPI open debugger connected to the PC, and check whether the drive is installed, if you can not identify, install SmartRF
Studio, he software that comes with the driver. If you can identify that, please give G1 on electricity.
If the drive is normal, then check the G1 and OPENDEBBUG connection is normal. After the G1 to power, press the CC
Debugger interface Open debugger next reset button.
40