Table of Contents
Advertisement
Operator's Manual: Seed Titan
Remote throttle doesn't work
No input power
Scale display is not working when power is ON
No input power
Incorrect Voltage
Dead battery
Internal fuse
Check for incorrect connection to the battery
Scale display turns OFF automatically
Insufficient power
5-2
2SE/4SE Box Seed Tender
™
Check charge of battery. Recharge or replace, as
required
Check connections in the remote throttle harness.
Be sure connectors are clean and terminals are firmly
pushed together.
Inspect the power cable for possible damage
Check the wiring connections for corrosion, bent pins,
or wire damage
The required Voltage is over 10.5 Volts with a negative
ground. If the Voltage drops to 10.1 Volts, the low
battery indicator will appear.
Make sure the seed tenders 12 VDC battery is fully
charged and the output is 12 Volts
Replace the 5 mm x 20 mm, 1 Amp, 250 Volt fast
acting fuse
Connect BLACK wire to Ground and WHITE wire to
+12 VDC
The indicator will automatically turn OFF if the Voltage
drops below 10.1 Volts
Revised 02.2021
Advertisement
Table of Contents
