Table of Contents
Advertisement
4. Press softkey [
] to send the Position Reply call.
5. Press softkey [
], and then press [
screen.
■
■ Test Call
You should avoid testing calls on the specific DSC distress channels and safety
calling channels. When you cannot avoid testing on a distress or safety channel,
you should indicate that these are test calls. Normally the test call would require no
further communication between the two stations involved.
] to return to the operating
■
◆ Sending a Test Call
1. Press softkey [
], the "OTHER DSC" screen is displayed.
NOTE: You can also display the "OTHER DSC" screen by selecting the "DSC
Call" item on the Menu screen.
2. Select "Type", then press [OK], "MESSAGE TYPE" is displayed. Select "Test",
then press [OK] or softkey [
3. Select "Address", and then press [OK].
4. Select a station to send the Test call to.
NOTE: You can also select "Manual Input" to manually enter the calling station.
5. Press softkey [
] to send the Test call, "Transmitting Test Call" is dis-
played.
NOTE: If Channel 70 is busy, the radio stands by until the channel becomes
clear.
].
29
Advertisement
Table of Contents
