Advertisement
Quick Links
Advertisement
Related Manuals for Oricom MX500
Summary of Contents for Oricom MX500
-
Page 2: Operating Rules
• Only use the original Oricom AC adaptor supplied with this product to • You must always monitor Channel 16 when you are not operating on supervises, ends the call and makes the necessary log entries. - Page 3 SETUP Setup The radio floats in fresh or salt water when the supplied accessories are attached. Scanning An LED sends out intermittent light from a transparent section on the bottom of the radios, while floating in the water. CONTROLS and INDICATORS Controls and Indicators Flashing lights Specifications...
- Page 4 Rotate the connector cap on the top of the transceiver to expose the charging socket. Carefully unpack your MX500 Radio. We recommend that you Plug the AC Adaptor plug into the socket on the top of the identify items listed in the following table before discarding the transceiver.
-
Page 5: Controls And Indicators
CONTROLS and INDICATORS ignoring untagged channel, in a channel group. Controls and Indicators [CH] Press and hold and turn radio ON to clear or set all TAG channels in the selected channel group. ANTENNA CHARGING SOCKET Connect the AC adaptor here. NOTE: Ensure the cap for the DC charging connector is affixed correctly to avoid water ingress. - Page 6 Each regular channel group has separate leisure-use call channels. The call channel is monitored during tri-watch. The call The selectable channel groups are different, depending on channels can be programmed and are used to store your most the version. frequently used channel in each channel group for quick recall. Weather channels may not be available in all countries (Australia does not use the weather channels please check channel 67 for weather reports)
- Page 7 activate flash Vibration Scanning When a signal is received, the scan pauses until the signal disappears or resumes after pausing 5 seconds, depending on the set mode setting. will flashing.
- Page 8 The set mode is used to channel the settings of the transceiver’s function: beep tone function, priority scan function, scan resume timer, auto scan function, dual/tri-watch function, monitor key action, automatic backlighting, LCD contrast setting and power save function. Weather channels may not be available in all countries transceiver.
- Page 9 remains open inactivity. The power save function reduces current drain by turning OFF the receiver circuit for preset intervals.
-
Page 10: Specifications
SPECIFICATIONS water. programmed.
Need help?
Do you have a question about the MX500 and is the answer not in the manual?
Questions and answers